Bosch configuration

From WikiSiwenoid
Jump to: navigation, search
Language: English

Previous chapter-> SPC6xxx configuration / Next chapter-> Paradox configuration


Configuring Bosch FPA5000 control unit

Bosch FPA5000 uses ethernet port to communicate with Siwenoid.

Createnode.png

In FSP5000 create an FSI server node under nodes.


Nodeedit.jpg

(The default Net Node, Group and RSN must be ok) Edit FSI server node's ip properties,

this IP Address will be the remote PC's IP. Multicast Address is also neccessary for siwenoid so as Port Number.

Assign bsch.jpg

Make sure your FSI server is assigned to every node.


Cpip.jpg

The node's (in which the ethernet cable will be plugged in) IP address (CP's IP),

multicast address (same as FSI server), and Port (same as FSI server) are also required to set in. Set the same on control panel.


Opcserver.jpg

Set the insterted OPC server license for the slot it is plugged in.


Validation 1.jpg

Validate every node's FSI server.


Siwenoid's broadcast address is the multicast address that you set here.‎


Previous chapter-> SPC6xxx configuration / Next chapter-> Paradox configuration