Sintony configuration
| Language: | English • magyar |
|---|
Previous chapter-> SNMP configuration / Next chapter-> Licensing
Sintony configuration with Sylcom
To be able to connect to the control panel with Sylcom, we will need a SAQ11 programming cable, which we need to connect to port J7 on the SI410 motherboard, the other end to the pc!
Let's open Sylcom!
(IF YOUR OPERATING SYSTEM IS LATEN THAN XP, THE PROGRAM HAS TO BE STARTED AS AN ADMINISTRATOR, EVEN IF THE ACCOUNT PROVIDES AN ADMIN ACCESS!)
Press login (no password required!).
The SI410 can provide serial connectivity to Siwenoid computers on the port J10.
When in serial mode, in the System Node of the SYLCOM tool, select the following options:
Networking mode = J10
Sending Node = WUD
Than go to "arc", and Disable the protocoll!
ATC-1000 configuration
UART Setting
- Mode: RS232
- Baudrate: 9600
- Character Bits: 8
- Parity Type: none
- Stop Bit: 1
- Hardware Flow Control: none
Connecting to Siwenoid
Host: ATC-1000 ip address
Port: ATC-1000 port
User ID: 3 (This is the default administrator user in Sintony)
Browse datapoint
