SPC6xxx configuration

Language:	English  • magyar

Previous chapter-> Detectomat configuration / Next chapter-> Lantronix configuration

SPC5300 and SP6xxx tool settings

The SPC6000 configuration tool is a web application that works with an Internet browser. The most common browser, Internet Explorer (IE), requires however a special setting: – In Tools, Internet Options, and then Advanced tab. In the option list, search for the Security options and enable Do not save encrypted pages to disk.

---

In the SPC6000 web-based configuration tool set in “Full Engineer” mode (refer to the SPC6000 documentation), note the following parameters:

• In Settings -> Comms -> Ethernet, set the SPC6000 IP addressing parameters ('IP address')
• In Settings -> Comms -> EDP, Add a receiver to the list and specify:
  • Receiver ID (unique number). The Receiver ID must match the SIWENOID setting
  • Network Address (IP address) of the SIWENOID server
• In Settings -> Comms -> EDP, select and Edit the receiver entry and specify:
  • In the Network section, the Network port (UDP port). The Network port must match the SIWENOID setting.
  • In the Event section, the Protocol version that must be Version 2
  • Primary Receiver must be checked
  • Requeue Event must be checked
  • Event filter list must be all checked
• In Settings -> Timers, make sure that Dialer delay is set to zero, else a delay occurs before alarms get transmitted to the SIWENOID.

'Generating the SPC export file'

• In File -> Download, browse and download the file

---

When the web tool is connected to the SPC6000 unit in Full Engineer mode, then no alarm messages are transmitted to SIWENOID.

---

In accordance with the previous list the following screenshots show the proper SPC settings:

Previous chapter-> Detectomat configuration / Next chapter-> Lantronix configuration