Siwenoid v2 Aritech configuration: Difference between revisions

Revision as of 08:45, 15 July 2021

Language:	English • magyar

Setting up the Atc 1000 for an Aritech control panel

For communication we will need an Atc-1000 Ethernet converter with the following settings.

The default IP address for the ATC-1000 is 192.168.2.1

Connect to a computer via Ethernet, then enter the above IP address into your browser.

Fill in the required username and password fields. (Default username: admin, password: system)

Once logged in, click "UART" in the left menu and set the fields as follows:

UART settings

Mode: set to RS232
Baudrate: set to 9600
Parity Type: None
Stop Bit: 1
Hardware Flow Control: None

Port setting

To communicate with Siwenoid we will need a TCP port, which can be set in the TCP Mode menu.
The Port is set to "23" by default. If we change it, note that it will be necessary to communicate with Siwenoid.

IP-mask-gateway setting

Set the IP for the ATC according to the network segment (Siwenoid will also need this) and the network mask and gateway.

Connection between control panel and ATC-1000

Communication will require a special cable, which must be made by hand.
We will need 2 9-pin female connectors and at least 4-core cables.
The connection is shown in the following figure:

@@ Line 41: / Line 41: @@
 <br style="clear: both" />
 [[Image:Tcpatc1000port.JPG|left|Thumb|1000px]]
+<br style="clear: both" />
+==IP-mask-gateway setting==
+Set the IP for the ATC according to the network segment (Siwenoid will also need this) and the network mask and gateway.
+<br style="clear: both" />
+[[Image:Aritechip1000atc.JPG|left|Thumb|1000px]]
+<br style="clear: both" />
+==Connection between control panel and ATC-1000==
+Communication will require a special cable, which must be made by hand.<br>
+We will need 2 9-pin female connectors and at least 4-core cables.<br>
+The connection is shown in the following figure:<br>
+[[Image:Airtechkabel.jpg|left|Thumb|1000px]]
 <br style="clear: both" />